Following an endless desire to know more and go faster!
If you own a Camaro or ATS chances are you have the same transmission I am using. The one piece I will be using is the stock throw out bearing. Unfortunately The clutch hose I received was cut and my car actually has a steel braided AN line today. I plan to simply unscrew the -4 fitting that attaches to the miata slave cylinder and thread this piece on. That should be all that is needed to operate the hydraulic clutch for the LTG.
Part Number 139160 from Summit Racing
This weekend I started cleaning the engine (Brake clean is the $hit!) with the intention of mounting the flywheel and trans in the near future. There are some cheap engine stands on amazon for $40 but I don’t feel they would bolt up easily. I will probably start to build and frame up something that will offset the engine and make transmission attachment plausible.
For the transmission I added a bar at the back with 2 casters. That makes it easy to pick up the one side of the engine and slide it around.
Car is in the background. I do feel the intake manifold will need to be replaced with something custom to prevent the large side bulge.
I could use some help. If someone knows the connector that I could replace the clutch line with I would appreciate it. The factory line was cut and this was the connector that is left (It goes into the clutch slave cylinder). Ideally I want this piece to a -4an fitting to connect to my Wilwood master cylinder.
